ORKO Auto
Model 3 Rear Bumper Reflector Replacement Lights
Model 3 Rear Bumper Reflector Replacement Lights
Couldn't load pickup availability
What's Included?
What's Included?
- Rear bumper reflector lights x2
- Included wiring harness
Installation
Installation
Step 1: Remove T25 screws (1 on each side) holding bumper to rear quarter panel
Step 2: Pull back trunk liner near outer tail lights to remove 2x 8mm nuts on the outer lights
Step 3: Remove tail light plug by lifting red tab on the connector and pulling straight out
Step 4: Remove outer tail lights by pulling straight out
Step 5: Remove 10mm bolt on top of the bumper where the outer tail light was
Step 6: Unclip the top of the rear bumper and pull back to access rear reflectors
Step 7: Depress clips holding in rear reflectors and remove reflector>
Step 8: Bore out center reflector guide hold (square shape) with a large drill bit to pass through the new reflector harness
Step 9: Pass through reflector harness into bored hole and feed wiring up
Step 10:Connect wiring harness to tail lights
Step 11: Clip in new reflector
Step 12: Reverse bumper removal process
Share
These LED rear bumper reflectors replace the stock reflectors; upgrading both the visibility and aesthetic of your Tesla's rear.
• High-Output LED Brightness
Delivers powerful illumination for increased visibility and safety on the road.
• Sequential Turn Signals
Integrated flowing turn signals that sync perfectly with the Cyber Tail Light’s animation for a cohesive look.
• 4 Style Options
Customize your look with two LED patterns, available in either smoked or red lenses:
-Smoked lenses offer a sleek, darkened appearance when off, but light up vibrant red in use.
-Red lenses maintain a bold red finish even when off, closely matching the OEM reflector look.
Note: Basic wiring is required. Professional installation is recommended if you're not comfortable with DIY electrical work.
